![]() ![]() ![]() Some of them are of a different size and have to go back in exactly the same hole! I laid out all screws on the bed, around the iMac, in line with the holes they were removed from. There are torx-screws all around the display. When you have one side up, you can lift the whole plate off and put it aside. Not too strong, the magnetism will give way suddenly and you must have control over your muscles so the lifting of the glass remains a steady movement. Stick them both on one side of the glass plate and pull up slowly. ![]() You can lift the glass plate with two simple, soft suction cups, like these: These pins break off easily, so remove the plate very carefully. The glass plate glues to a magnetic border and additionally has some pins sticking out to keep the glass from sliding or falling off. Turn the iMac around and lay it on its back. The memory access door is a bit bent - this is done on purpose so that when the screw is removed, the door comes out and you can take it out easily. Remove the memory access door at the bottom of the iMac: I used a bed :-Dĭischarge and/or ground yourself by either touching the radiation system or something else and/or use a grounding wristband. until 2012), you have to open it up! Since you cannot see any screws from the outside, where are they?ĭisconnect your iMac from everything and lay it flat on its screen on a soft surface. If you want to replace the hard disk in your Intel iMac (as of 2008. Get to the hard disk of an iMac This is an iMac from 2008 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |